USED EDGEBANDERS BRANDT & HOMAG
 | ||||
USED MACHINERY
Browse By Application:
1011-7
BRANDT KDN 350 C EDGEBANDER (Used)
Model: KDN 350C; SN: ; Year:2003
220/440v; 3ph; 60hz.
Feed speed of 30 FPM. - Equipped with: Operator control panel at eye-level, automatic height adjustment with top pressure beam for all workstations; electronic line control (no limit switches), digital height indicator on holddown beam, electronic motor brakes on trimmers.
0.4 - 3 mm (1/8") Edge thickness cap., 8 - 45 mm panel thickness, 60 mm min. panel width and 140 mm min. length.
Equipped with: Infeed heating shoe to pre-heat panel edge; Hot Melt granulate glue system with fast start-up (10 - 12 Min heat-up) with reversible rotation glue applicator roller and automatic reduction glue temperature adjustment (when idle drops to 150°it takes 2-1/2 Min to re-activate).
3 mm PVC Pneumatic guillotine for coil cutoff, automatic feed magazine, coil stock feeds automatically with guillotine cutoff, all strip stock are fed automatically through strip feed magazine.
2-Roller pressure section (1st driven, 2nd idle) w/electronically controlled & feed speed synchronized drive roll.
Workstations: Vertical travel double motor front & rear end trim with 0° - 15° horz. bevel cap. (0.25 HP - 12,000 RPM motors);
Top & bottom flush/bevel trimmers (0.35 HP - 12,000 RPM), bevel 0° to 15°.
Single Corner -Rounding station;
Top & bottom PVC scraping unit for up to 3 mm radius;
Last Station: Top & bottom buffing unit (0.15 HP - 2,750 RPM motors).
$40,000.00
Replacement cost: $65,000.00 (approx.).
FOB: Minnesota.
This machine is offered “in good running condition as taken from service” and is subject to prior sale.
Specifications are approximate and to the best of our knowledge. Verification is available upon request
