USED EDGEBANDERS BRANDT & HOMAG
 | ||||
1112-10
BRANDT KDF 530C EDGEBANDER (Used)
Model: Optimat KDF 530C; SN: 0-261-02-9xxx; Year: 2006.
230/440v; 3ph; 60hz.
Edge capacity: 0.4 - 8 mm (5/16");
Panel thickness 15/32" - 2-5/32";
Min. panel length 160 mm (6-3/8") and 65 mm (2-1/2") min. width;
line control (NO limit switches) for workstation function.
PC-16 Program Control; with 7-1/2" VGA screen 8 MB IDE flash disk, 8 MB RAM, Internal Modem for remote diagnostic link;
Signal infeed light to insure proper spacing between panels.
Glue applicator roller is reversable and retractable from the fence line.
Pre-Mill station up to 45mm.
Automatic magazine for strip & coil.
3 mm PVC guillotine;
(1) drive plus (1) split secondary roller pressure sections.
Workstations: End trim (1/3 HP - 12,000 RPM motors), chamfers 0° - 15°via programmable controller;
Top & bot. flush/radius trim, bevels 0° - 15° (1/2 HP - 12,000 RPM motor);
Top & bottom scraping for 3 mm radius with pneumatically controlled indexing system;
Single motor Corner-Rounding;
Top & bottom buffing (0.25 HP - 2,800 motors).
End trim & flush trim stations have HF motors w/electronic brakes;
Feed chain track speed 36 FPM, 2 HP feed drive.
• Complete with: Operator control panel w/PLC (Programmable Logic Control) keypad & LED readouts, and used tooling.
$48,500.00.
Replacement cost: $105,000.00 (approx)
FOB: NC.
This machine is offered “in good running condition as taken from service” and is subject to prior sale.
Specifications are approximate and to the best of our knowledge. Verification is available upon request.
USED MACHINERY
Browse By Application:
