0809-09
POLYMAC LATO 28 EDGEBANDER (USED)
Model: Lato 28; Year: 2004; SSN XXX.
380 V; 50hz; 3 Ph.Pre-Milling Section equipped with (2) 1.64 kW (2.5 HP) motors, 12,000 RPM; PLC controlled adjustable copy device w/numerical readouts, pneumatic extraction when not needed.
0.4 - 15 mm (5/8") Cap. edgebanding thickness, min. panel width 50 mm & min. length 160 mm, max. panel thickness10-50 mm; automatic strip & coil feed magazine with robust shear type 3 mm PVC guillotine (6" pack cap. for strips).
Workstations: Front & rear end trims (0.5 HP - 12,000 RPM motors), motors travel on 45° slides with pneumatic tilt 0-15°; top & bottom rough trim (1.0 HP - 12,000 RPM motors), digital readouts for easy setup; top & bottom Fine Trim with "Quick Change" tilting motors (0.5 HP - 12,000 RPM), motors tilt 0° - 30°, cutters for 10° bevel & 3 mm PVC radius round; digital readouts for easy setup; Multi-Function (0.3 HP - 12,000 RPM motors) corner rounding unit for trimming leading & trailing upper & lower edge/corners; top & bottom "Profile Scrape" with pneumatic exclusion for 3 mm thick PVC banding, pneumatic pressure control for scraping knives, digitals for horiz. adjustments; top & bottom (3,000 Watt) LEISTER hot air blowers with temperature adjustment; Top & bottom buffing (0.5 HP - 3,000 RPM motors), units tilt 0° - 30°.
Motorized top pressure beam. - Feed track with "anti-slip" "Quick Change" snap on 80 mm wide X 60 mm long rubber pads, low friction nylon-graphite self-lubrication chain pads, variable feed speed from 32 - 65 FPM, 3 HP feed drive.
$25,500.00.
Replacement cost: $35,000.00 (approx)
FOB: CT.
This machine is offered “in good running condition as taken from service” and is subject to prior sale.
Specifications are approximate and to the best of our knowledge. Verification is available upon request.
USED EDGEBANDERS
| ||||||
USED MACHINERY
Browse By Application:
