USED EDGEBANDERS BRANDT & HOMAG
 | ||||
HOMAG EDGEBANDER (Used)
Model: KAL310/3/A3 ; SN: 0-200-XX-XXXX; Year 2004.
220/440v; 3ph; 60hz.
Edgeband thickness cap. 0.4 - 3 mm;
Min. panel width 55 mm; maximum panel thickness 60 mm.
Feed speed variable up to 18 to 32 m/min (59' to 104' FPM); 80 mm Feed track pads, and V-groove belt on top pressure beam which manually adjusted.
Hot melt glue system "A34" with reversible glue roller applicator; Pressure roll section with (1) large dia. driven & (2) idle rollers; manual adjustment of pressure zone through SIKO digital counters for different edge thicknesses.
End Trimming "HL-81" (2 x 0.25 HP - 200 Hz, 12,000 RPM each) to cut excess edge on the front & back of the panel;
Open Space # 1999 of 600 mm (23-5/8") for adding rough trim station at later date.
Top & Bottom fine/profile radius trim unit, 0° - 30° tiltable, (0.4 KW - 12,000 RPM) each motor, SIKO digital adjustment.
Profile Scraping Unit, for PVC; (Set up for 3mm).
Buffing Unit, Top & Bottom # 4402 (0.25 kW - 2,850 RPM) each motor.
Line control with HOMATIC "PC 22" controller features, function in Windows environment; Keypad w/LCD display, fault diagnostic, etc.; diagnostic analysis from HOMAG service support via Modem.
Complete with: SIKO Digital adjustments; electronic DC brakes on all trim motors, sound cabin for all workstations, adjustable outboard panel support with swing out arms for up to 800 mm.
$52,500.00.
Replacement cost: $125,000.00 (approx)
FOB: Washington.
This machine is offered “in good running condition as taken from service” and is subject to prior sale.
Specifications are approximate and to the best of our knowledge. Verification is available upon request.
USED MACHINERY
Browse By Application:
